HW9830 Jet valve performance parameters

Minimum driving pressure

0.6 MPa

Maximum operating frequency

250cycles/s

Optimal feeding pressure

0 to 0.3Mpa ?

Minimum point diameter

The 0.2 mm

Adaptable glue range

0~200000 Cps

Overall dimension

155 mm×125 mm×30 mm

weight

600 g

Feed assembly

Stainless steel Luhr connector cartridge (standard)

Flip joint feed pipe (optional)

Fluid tank growing side feed (optional)

Can be connected to cylinder specifications

3CC, 5CC, 10CC, 30CC, 55CC

Feeder pipe specifications

4 divided, 6 divided

Main valve body

Stainless steel

Fluid cavity canal

Stainless steel

Firing pin assembly

Special high strength material + SUS303

Nozzle assembly

Special high strength material

Fluid seal ring

PTFE+SUS 304

Gas seal ring

polyurethane

Other O-rings

Nitrile butadiene rubber

Solenoid valve

24V (DC) 5W

Heating block

6061 AL anodized

Heating tube

24VDC or 220VAC 80W

Maximum heating temperature

150 ℃

* Note: The above HW9830 injection valve performance parameter values are obtained under specific pressure and fluid parameter conditions. In practical applications, it needs to be determined according to the actual glue characteristics and specific measurement conditions.

?: In actual application, it should be adjusted according to the actual glue characteristics, but the maximum feeding pressure should not exceed 0.5Mpa, otherwise it will affect the status of the moving parts inside the valve body;